Questions & Answers for: Chrysler Sebring throttle body

...how hard is it to change on a 2000 chrysler sebring conv 2.5L its located on the opposite side of the throttle body as the throttle cable. remove the whole throttle body then remove the TPS from

...throttle body near the throttle plate.  It may have become stuck with deposits.Clean the throttle body as well.  Check for vacuum leaks check to make sure all vacuum lines are on especially ...

throttle body air inlet hose. Disconnect PCV hose from intake manifold. Loosen hose clamp at throttle body air inlet hose. Remove hose from throttle body Push in on locking tabs to disengage air inlet

...throttle body. By removing the air intake you will see the butterfly of the throttle body. Using throttle body cleaner open the butterfly and clean out. The first few times you may have difficulty ...

...throttle body.You can now see the butter fly plat that moves as you step on the accelerator. Spray some throttle body cleaner on the plate both sides,and scrub with a tooth brush. now take a rag with ...

...for the throttle body. It's should be connected to your air filter housing. Just try to clean the sensors and use the spray for the throttle body and that should help. Good Luck... It work for

what the throttle body looks like and where is it located on 2007 chrysler sebring follow the hose from the air filter to the engine and where it ends will be the throttle body assembly.

throttle body sensor My car would come to a complete stop and then when I begin to accelerate it pulls back. Im thinking it could also be the timing belt? It sounds to me like a transmission problem. ...

where is throttle body location From the air cleaner box will be a rubber/plastic tube, leading to the throttle body

Where is throttle body sensor located on 2007 chrsyler Sebring 2.4L on side of throttle body.