Questions & Answers for: MTX three way

amp has burned up there are three transistors on the left side that have burned up under the heatsinks and i cant figure out y or where to find replacements for them this was a used amp and when i was

...when frequency, EQ, and gain is turned all the way up, or at least halfway up. Even then, w/ all three 100% up, it only produces weak power- maybe a cpl hundred watts. Of course at that point, not ...

...when frequency, EQ, and gain is turned all the way up, or at least halfway up. Even then, w/ all three 100% up, it only produces weak power- maybe a cpl hundred watts. Of course at that point, not ...

...when frequency, EQ, and gain is turned all the way up, or at least halfway up. Even then, w/ all three 100% up, it only produces weak power- maybe a cpl hundred watts. Of course at that point, not ...

1501d When i say "only feel current running through woofers", i mean w/ all three controls- freqency, EQ, and gain- turned all the way down, it produces no sound like normal, but when you place your ...

...to restart. Starts again without any problems and runs GREAT. Tried Lucas injector cleaner for three fill-ups, no luck. Was advised on replacing coolant temp sensor, I havn't done it yet though. ...

on. however my fosgate will. i tried swapping fuses, tryed new ones and all it will do is flash two three times wait a few seconds and it will flash again. i was wondering if there is a reset switch i

GOT 3 MTX THUNDER6000 10 IN SPEAKERS IN A NON PORTED BOX GOIN TO AN ORIONXTREM900 AMP WHATS THE BEST WAY TO RUN IT run all three positive to negative and bridge them at the amp

shorted the output transistors and replacing them will fix your issue. inside the amp you will find three legged transistors that mount to the amps body/heat sink. replace all of them. good luck man

can I get a diagram for the circuit board for my te 604, I need to replace three of what look to be three leg diodes Amp got wet and burned what looks like three little square three leg diodes. ...