Questions & Answers for: thermal cutout Vacuums

...thermal cutout a 131 degree C component on the PCB in the docking station for the vacuum when recharging, I also had to change the LED which had also failed this is a Red 12 volt 5 mm dia component ...

...thermal cutout. Check all air hoses and inlets for clogs. If all of your air pathways are clear, you most likely have a bad motor bearing, also indicated by a high-pitched squealing sound. If that's ...

...thermal cutout on the motor causing this problem because it is overheating. Either it needs the filter replacing and a good blowout with compressed air or the thermal switch is faulty. Try replacing ...

thermal overload cutout) on the motor is getting too hot - thats why it keeps shutting off and starting again once its cooled, so make sure your filters are clean and they are no blockages in the hose

...thermal cutout switch in the motor. My problem was a result of a filter being removed and the bag not seated correctly, hence dirt got into the motor and clogged the turbine, reducing airflow through ...

...is straining and overheating, then a thermal cutout operates. Clean the filters in the top of the vax and if you are ussing a cloth bag empty and wash ot. If a paper bag, replace it. All should be ...

...switch? It would have to safely be taken apart and voltage to the switch measured to know, just be careful. Most have a thermal fuse or cutout that if the motor gets too hot will trip all power

...it may be an internal fuse or thermal cutout. Please advise. it is the switch this is common for these vacuums and a new switch will fix it I come across this problem a lot when I am repairing ...

...thermal cutout sensor, which will shut the machine down for protection if something causes it to overheat. This will reset itself automatically once it's been allowed to cool down for at least three ...

...thermal cutout it should have reset within half an hour. Could be that the long operation caused motor to over heat and damage some of the windings. Also make sure that the motor is receiving power. ...