Questions & Answers for: Buick test mod

I need to ask is whethe the key has a "pellet" on it which most call a chip. what you need to do is test the resistance on the key itself. If that key does not send a signal to the VATS system the car

...water pump. I'd start with that one since you dont need a pully to get to it. Auto zone and napa test the ignition mods and say they are good, but the test they run on them does not get them hot ...

...mod. and fuel filter. The code read crank sensor, i replaced it , same problem. It will run fine then just quit, usually when i am coasting to a stop. I even tried another battery and cleaned all the ...

...test the blower motor itself. I am almost at the point of removing the blower control module, but am stuck at a removing the Dash Integration Module off of its mounting bracket. I can't tell how the ...

...to work 4 miles at 9am come out at 12 car wont turn over sounds like its not getting gas, had it tested they say its my ignition mod purchace new one it wont start car put old one on car stars,

...mod $10 5 volt ref circut that code has to do with voltage there are four circuits that have to have five volts ( egr , fuel tank, throttle postion sensor, and Map sensor) unfortuatatly you need a ...

...test light, &gnd (ABCD), Ign Cntrl Mod now at 12V DC at A&D pins w B pin at 2.8 V AC & C gnd. Initial code 41 on dashboard diag and now cleared after replacement of Ign Cntrl Module. No ...

Installed new battery, car turns over but won't start Have the ignition control mod. tested. It is locked unde the coil packs.