Questions & Answers for: Ford Ranger test lamp

1988 Ford Ranger My Headlights won't work all the other lights work in the truck inside and out. I tryed a new headlamp switch put its still not working. I tested the power going directly to the ...

...the wire harness by using a volt meter. use the internal cooper prongs in the head lamp plug for

...lamp test if you test positive voltage at the terminals of the nozzles when you start the engine gives positive and see if you have negative voltage when the motor turns negative if you check whether ...

...test lamp , ground test lamp and probe each wire. 1 will do nothing (earth wire) 1 will bring on dash low fuel light , the other will be the gauge on the dash which will rise (slowly) to the full ...

...that DTC'S - diagnostic trouble codes are stored that will point a qualified tech to a problem for testing , electrical circuit's ,componets etc.... You have no idea of the complexity of these ...

...test lite to check for voltage at fuse and at fusible link. The wires on top of switch in the diagram are voltage to headlamp switch, the wires on the bottom is voltage from head lamp switch to ...

...Test lamp: Disconnect the cable that connects the power to the head light bulb, Connect one end of the test lamp to any one of the connectors at the end of the cable that plug's into the bulb. With ...

test with a scanner & look at & record all data. I would say 100% of all drivability testing is done from 35 to 58 mph & I personally seldom drive 70 & won't get in a vehicle driven by

...test lamp to verify START/RUN voltage at the ignition coil harness connector. Check the coil driver circuit for open, short to VPWR, or short to ground. Application Key On Engine Off Key On Engine ...

...box (CJB) fuse 10 (7.5A). Circuitry. Multifunction switch. Indicator flasher. GO to Pinpoint Test H