Questions & Answers for: Isuzu Pickup test ignition coil

...have also disconected battery trouble code still appears replace ignition coil make sure by dealer the right mode is used when ordering if not ordered right you will get a difference in engine ...

...test ignition module? Take it down to most any parts store, they can test if if they advertise module testing. Check the coil and see if there is between any of the contacts. They can probably test ...

...ignition coil. same problem, does not seem to be getting power to the coil. checked fuses also made suer it was getting fuel.  Change the crankshaft sensor.That is your problem.They can fail ...

...ignition coil if it goes bad.Now quality means a lot in selecting the brand of ignition,standard ignition,and echlin ignition are the top of the line in stock automotive parts,standard ignition,is ...

...RPMs are higher 1= you must have various problem, example the pistons, crankshat, the ignition system, etc.test your vehicle with scanner and computer system for properly troubleshooting.God bless ...

...Coil was just recently replaced and ignition module and the crank senser was tried by a friend and still nothing there is a very low signal going thru both signal wires i need 5.0 volts and only have ...

ignition problem so i went all through the system and wound up replacing the control module and the coil. after that she runs but not like she did before and when im trying to start its like the motor

...kb300 no power above 3000rpm. we took it to delta they did the diagnostics no fault codes found, tested airmass meter,diesel filters,egr valve,throttle sensor,eng.coolant temp switch,and boost ...

...coil you should have power ,and on the neg side you have power only when you spin it over {so get a test light and put wire clip to earth anywhere on engine bolt,and put the point on to +then turn on ...

...with isuzu 2.2 d/cab no spark from coil to spark plugs,engine cranks normally but does not start.tested the coil on another same vihecle and it is ok.what could be the proble mi check crankshaft ...