Questions & Answers for: RTO terminal

...to starter. That will crank up the starter. just use a screwdriver and wedge it between the two big terminals on the relay to make contact to each other and the motor will turn over. You can also run ...

...when it does things like that. The 240 volt clock motor is internally connected at the factory to terminals 1 and 3. That means that one of the incoming (line) 240 volt wires (pick one) _must_ be ...

...link: http://waterheatertimer.org/How-to-wire-T104-Intermatic-timer.html#T101 Hot wire goes to terminal 1 Neutral to terminal A Black wire to pump goes to terminal 2 White wire to pump goes to ...

cant get the timer to power up, I know incoming power is on 2 and 7 .do i need to jump to other terminals? RTE-p1ad is 24-volt AC 8-pin on-delay timer. Manual for RTE-P1 & RTE-P2 ...

...do I connect my 2 speed pool motor? 1) You might need a different timer. 240Volt T106 has one NO terminal and one NC terminal. ...

...For example Line wires are 240Volt, and there is 1 black wire and 1 white Black connects to terminal 1 White connects to terminal 2 Add a jumper wire (short piece of same-gauge wire) from ...

...motor is a 220 v 3/4 HP it worked on the intermatic. any suggestions? Necessary for you to match up terminal numbering with actual numbers for each timer. Information below is for 240volt timer ...

my fans on my brand new sole f80 dont come on 1( test the voltage at the terminal of the FAN, if there are the FAN is faulty.2( test the voltage at the terminal , if there are NOT TEST why NOT coming ...

I have a G6A-3E heater. didn't work untill I cleaned the terminals on the t,stat It works but shuts off befor the water is hot! after allowing the mach. to cool it can be turned back on & runs

...please see the video attached and proceed according. However you must test the power voltage input terminal motor use the multimeter, see my personal TIPS for Motor HELP.if there ARE the motor is ...