Questions & Answers for: Admiral terminal

...you connected the timer up wrong, from my drawing check the following connections to the timer. terminal 12 & 26 - Black (linked) mains supply terminal 17 yellow/red (from rinse switch) terminal ...

...ensure the small hose is connected, or with a mais tester check the output (orange/purple wire terminal 2), no mains voltage=no water, the input is grey (terminal 1) from the timer and should be ...

blk wire burned off at heating element admiral dryer ade7005ayw i replaced terminal once whats cauing it to burn off lets see hear.a loose connection draws maximum ampreage so important that any ...

...for continuity using a multitester. Set the multitester to the ohms setting X1. The timer has four terminals. Locate the common terminal, it should be labeled "3" or "C". If the terminals are not ...

Coils do not self defrost Ice accumulate on coils behind the fan panel. I t keeps bulding up until blocking the cold air vent from the freezer to the frig. Why are coils not self defrosting. first ...

...with a warm, wet towel first. There are two wires leading from the thermostat. They are attached to terminals with slip-on connectors. Gently pull on the connectors to release the wires from the ...

...and cord that will fit the receptacle then put the RED and BLACK wires on the cord on the 2 outer terminals on the dryer or L1 & L2 terminals,then the white wire on the cord to the center ...

...dryer itself have some sort of fuse that might have blown? Have you tested the voltage at the dryer terminal block? Left stud to the rht stud should read 240 vac. both outside to center should be ...

Tony, I checked the fuse first and jumped it but that didnt work. any other ideas? Check for voltage at the fuse terminal.

admiral washer 8 years running good, now only drain water out won't work. took hoses off under neath not clogged how do i figure if pump bad or switch? see if pump is turning or use a bed side lamp ...