...low temperature Check blinking of the heater lamp with SIM 5-2. When the lamp blinks normally: Check the thermistor and the harness. Check the MCU PWB thermistor input circuit. When the lamp does not ...
Question about AR-5316 Advanced Digital Imager Copier
Low Temperature H5 Lower thermofuse H6 Lower thermistor H7 High temperature in lower roller H8 Low temperature in lower roller L1 Forward Scan L2 End of Scan L3 Return of Scan L4 PT/main motor L5 Lens
...Low Temperature H5 Lower thermofuse H6 Lower thermistor H7 High temperature in lower roller H8 Low temperature in lower roller Is Not corrected fuse, you do not throw the sodas of the mistake until ...
...not reach the prescribed temperature within the given time after the start of the heat roller warmup operation.2- If an irregularly low temperature was met after reaching the prescribed
low temperature", possibly caused by a failure of the heater lamp or fuser. Sometimes this error is shown without an actual damage when the power cord is pulled without shutting down the copier first.
...low temperature content: heat roller abnormally low temperature.reset: pressp/# --> * --> clear --> * --> 14 --> startcause:1- thermistor failure2- heater lamp failure3- thermostat ...
...low temperature detection Detail When the fusing temperature is lower than 150Cafter 55sec from the start of warming up. When the warming up complete temperature is not reached in 30sec from reaching ...
...low temperature When the temperature does not reach 155°C within 55 sec after turning on the power, or when it falls under 145°C during printing, or when it falls under 100°C during ...
Question about MX-3610N Color Photocopy, Print & Scan: MX3610N"
low temperature detection When the fusing temperature is lower than 150C° after 55sec from the start of warming up. When the warming up complete temperature is not reached in 30sec from reaching 150C°
Question about MX-3610N Color Photocopy, Print & Scan: MX3610N"
low temperature detection. The setup temperature (about -25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from turning on the power ON SW. (When the temperature falls below 140
Usually answered in minutes!
1,105 Questions
603 Questions
557 Questions
331 Questions
354 Questions