Technics SL-BD22. The belt was only $10. (Shipping extra. My shipping was $4) I just finished putting it on and it works like new. Turntablebasics also provide instructions on removing the platter and
...Technics SL-BD22 has come completely off, how can I put it back on? Ok.Thats a difficult part to explain on a pick up.So listen up and give attention.Take off the plate of your driver and adjust the ...
Technics SL-BD22 is a belt driven turntable. It is most likely possible that the belt wore off, wore down, or could have spun off. The platter should have 2 holes in it. One of them should alow you to
technics sl-ql 15 linear tracking T/Table missing arm screw that secures TP4 cartridge in arm. probably same as others in range as SL-5 one works fine. [email protected] Parts are discontinued for ...
...SL-BD22 ? Are there any specific problems in replacing the drive belt ? Nope, very simple... 1) Remove the platter - just lift up 2) Underneath the platter, you'll see a small lip section 3) Wrap the ...
...technics turntable SL-BD22 Could you please provide me with a spare belt for a Technics turntable SL-BD22 or give me an adress where to order for that piece (Belgium). I thank you in advance ...
Technics SL-BD22 turntable and it came without the ground wire. Is there anywhere I can purchase this proprietary part? just get any small speaker wire and use that as your ground , attach that to the
...in place. Earth cable available here :- ...
...technics sl-BD22D turntable, would anybody no if there should be an adj weight on the rear of the tonearm that you slide left/right to prevent skidding? or are they just fixed which this one seems to ...
...size belt on the SL-Bd22 Just purchased a belt for my SL-BD22 from Vintage Audo (Audio?). The belt size is 23.6 X .180 X .025 inches. Their part number for this belt is:B00926DJ74. Hope this
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions