overheating Upon pressing the help button, it displays "HIGH TEMP REDUCE VOLUME" After few minutes the whole receiver is hot. Be sure there is room around your receiver to breathe. Be sure the fan is ...
technics surround sound system trying to hook up tv to surround sound Use whatever TV sound output conforms to your receiver's input. If an optical or coaxial digital sound output is available, that ...
...technics sa-dx1050. its say (F 10)on the display.and then switch off.what can i do?to reset it. Operationg instructions says it is "F 70". When it appears it says to turn the unit off, disconnect the ...
...Technics SA-DX1050 reciever. I can't get true 5 speaker surround sound with a movie. I can get the front center and back 2 surround speakers to work at once but not the front left and right at the ...
Do you know where I can get a cooling fan replaced on a Technics AV Control Receiver Model # SA-DX1050 close to Fort Worth, Texas Check for Local Electronics Store
i need a cooling fan you need a bigger amp
when i turn on the receiver it immediately gives me a ¨F70¨ error message on the display hi there, This is a problem related to the out put section, try disconnecting alls the speakers from ...
I'm wondering if it is possible to turn both speakers A and B on when it says "low imp" next to the [A] [B] section of the screen. sounds like and impedance issue . is it set up within the ...
Technics SA-DX1050 receiver. The speakers are from Bose Acoustimass System. I cannot get the front left and right speakers to work. The center speaker works fine, the rear surround speakers work fine.
technics sa-dx1050 overload unit goes into overload even without speakers. if any one of the channels was shorted out, even momentarily, that channel's output transistors would likely be blown ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions