Questions & Answers for: technic amplifier overload

Tecnics SU-G95 stereo overloaded Our technics stereo sytem says overloaded, we have no volume and keeps running overloaded on screen. Power down,disconnect the speakers and power back up. If it still ...

...you hook up many speakers without damaging your amplifier. You will overload the amplifier if too many speakers are attached to amplifier. See MCMELECTRONICS.COM such as P/N 50-2202 or ...

...amplifier SU-G95 says over load how or what part do i need to fix it. overload is protection from very big signal input-or high current output. 1-keep your input signal between -10db-----to 0db. ...

...overload still flashes. What's up? An amplifier should never be turn on without speakers, it will overload internally. make sure speakers work and try again. My speakers are disconnected and it still ...

amplifier and the fail safe circuit is trying to protect the rest of the circuit. 2. there may be a voltage overload at the primary side of the power supply circuit which in this case is causing it to

technics amplifier saying its overload The amplifier ic is probably damaged! Check voltages and solder connections to verify.

overload error with no volume no speaker cords attached overload Hello, if its overloading, reduce the amount of speakers connected to it. Or you can get a small fan and direct it to the Amp while its

...amplifier After the unit is switched on it works for 5 minutes then it stops and the message OVERLOAD - SWITCH OFF POWER runs across the display. It also does this when all phonos and speakers are ...

SA-AX530 Receiver: the display show OVERLOAD,THE AMPLIFIERS ARE OKAY,... The display show overloadthe amplifiers are okayhow can I check from where comes overload check for shorts on the speaker ...

I have a Technics SU-G91 amp that is stuck in overload even with no input. I have tried giving it a quick blast of air to dust and still nothing. All help is appreciated!! Your Technics unit will ...