Question about R-1850A Convection/Microwave Oven
...tab button is pushed. While the door was open I looked at the inside where the latches fit... when you push the button tab you can see something moving. I'm assumming this is the piece that releases ...
...tab on your door open button (drawing ref. 3-2-4) or a broken door lever (ref # 4-25). The button is normally held out by the spring. You can find the entire service manual for the R1870/R1871 at our ...
[email protected] http://www.microwavedisplay.com I had this problem. It turned out the connector tabs on the door microwave switches were dirty, the accumulation of about 10 years of greasy gunk.
...button is not working. The others are working but when you press start nothing happens. We have the service manual for this model and have uploaded it to our site here to help you. You will need the ...
...button works but when you press start nothing happens, and the light in the microwave does not go out as if the door is still open. It's usually a broken tab on the upper switch holder, allowing the ...
...button is actually a tab that you can carefully remove by using a butter knife and sticking it in above the tab where the plate meets the top. The tab is about 1/4 inch long. After you remove the tab ...
to do after you remove the cabinet. The button you push to open the door is held in place with four tabs. If one of them tabs break it jams the button. When used in normal/non-microwave mode, the door
Question about Profile Spacemaker Over-the-Range Microwave
GE Profile Spacemaker 2.0 - black buttons on panel for vent, boost, and light broke . Any way to replace the buttons and take the panel off? I had the same problem. The front plate is tabbed into ...
tab broke on the push-botton that opens the door, so now the button pops out everytime it is used. I need to replace the entire push-button assemlby. Any idea where I can get the part? You can buy the
...those buttons are on a separate small board. Sometimes that board breaks loose from it's support tabs; other times the buttons just go bad with age and use, and you need to replace that button ...
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions