Questions & Answers for: how to switch it from tray 1 to tray 2 Computers & Internet

...tray upper limit switch) or the S3 (Elevate tray lower limit switch) is turned ON in the specified period of time after the elevate tray starts to drive. The main body stops immediately, and the RL1 ...

...switch to tray 2 IF BOTH TRAYS are set to the same paper size "OR" if the paper sizes are different, the machine will switch to the lower (14") tray when it recieves a document which is 14" long. You ...

...switch the tray stands still. When I release the top switch the tray goes to the top. I have to take the tray motor out to reset the tray and disconnect the switch to get it to stay otherwise it ...

...Tray - Booklet Finisher Locate the gray cables that are connected between finisher and main unit. Check that they are secure, and that the cables are in good condition. Switch off the device at the ...

tray in place. Have found the micro switch inside and pushing this down "fools" the machine into thinking the drip tray is back in place, but then when the tray is put back into position the

...trays them self? There are switches behind the tray for paper present and paper size.... You may also have broken switch in the back of the copier..... There could be a few other things..... Good ...

...TRAY MISSING" small white relay switch deep inside the machine. use a flashlight to visualize the small switch. verify that the switch is securely mounted and clicks when depressed (up) using a soft ...

...displays on the printer control console that indicates which output tray is full. • In automatic switching mode, the system automatically switches over to the second tray (if it is empty) when ...

...tray The switch has become faulty overtime and needs,a replacement The bit on the tray that pushes the tray loaded switch has broken off the tray is missing the switch or a wiring fault has ...

...Tray switch tells mechacon that the tray is shut. Attempt to focus on disk. If focus is acheived, then it will spin up and try to read the disk otherwise it will ask for a readable disk. If the tray ...