Question about CHT-12 Subwoofer
sub-woofer does not turn itself on in 'Auto' mode (signal driven) I constantly have to switch it off then on again, and when I turn it on again the next day, it will often not turn itself on although ...
...switch back on. Then it will work for a short time as long as I have the volume turned up above low. I have an Onkyo TX-SR 606 with Jamo surround sound speakers. I recently purchased this receiver ...
...I'm VERY irritated, since I didn't expect this from a Velodyne sub. I have a second DD-10, and I switched the interconnects and power cords betweem the two just to make sure it is the one sub that ...
...I'm VERY irritated, since I didn't expect this from a Velodyne sub. I have a second DD-10, and I switched the interconnects and power cords betweem the two just to make sure it is the one sub that ...
Question about DD-10 Subwoofer
...i I tried to unplug the RCA, leaving only the power cable. Noise still coming out from the sub. I switched power cords, changing to different outlets, but those dont help. appreciate anyone that
switch my amp off and back on to get the green light. Can you help? Tks Here is something to try. On your signal source, check the owners manual for adjusting out put levels. If it has one for the sub
sub has started humming with amp turned off. just turned on at wall switch.nothing running If the hum is from the back of the unit around the amplifier, it may be the transformer. It could be that the
...switch. sub woofer is extremely sensitive, vol contrl switch is on 0 (the loest) and still makes noise on certain low requencies. I'm a home owner, now retired in Fla and miss my sub woofer. thanks ...
CHT-10R switching on but no longer producing sound My Velodyne CHT-10R began cutting out after operating for about 10 minutes. By switching it off and on again, I was able to get it to work again, but
Usually answered in minutes!
20 Questions
15 Questions
15 Questions
13 Questions
16 Questions