...switch was burned out and needed too be replaced. I replaced it. My car is a 1999 Sebring. The switch is located under the dash on the heater plenum at the heater. It worked just like new again. BUT, ...
...for the power switch burned out for the connector. there are 3 wires going to that switch. I am looking for a wiring diagram for the switches. can you help bk-hot wht-ntrl gr-grnd on fan bare is ...
Question about 1999 Monte Carlo
...bulbs. It may not be that problem at all. Do your turn signals work without jiggling the switch? If not then you need to replace the turn signal switch cause it's messing up and Chevy ...
Switch burned out on Lakewood radiator heater. Switch burned out controlling three wattage settings. Where can I get a replacement switch? Hi, go to amazon.com and you can get a switch for the ...
...the contacts may have corrosion or have burned when the headlight socket had a problem. Other than the dimmer switch this is another possibility to consider. Good luck and thank you for
...switch burned out bulb in four wheel drive dash switch burned out if it burned out, but the 4wd works, the only way to fix it is to remove the dash. you might have to replace the switch, or just the ...
burned out and now the switch will not turn the other bulb off it stays on at all times so we now pull the plug. We are thinking the switch shorted out when the bulb burned out but why did a bulb burn
Question about NN-H764 Microwave Oven
Driver's window keeps burning out. Window goes down fine, goes up easy with new switch, but in a few weeks the uo portion of the switch burns out have replaced 3 switches in 2 months. the ...
Question about Fast Tractor YTH24K48 48" 24HP Kohler Lawn Tractor 2012
pto switch shorting out is the switch burning up or will it just not ingage blades?check seat switch as well it all works togather.most of the time there is a dioed in clutch wiring system that burns ...
Question about DS141 Headlight Dimmer Switch
this problem Most likely cause will be loose/burned female terminals at switch connector,other inline connectors or possibly by an add-on alarm or other device causing hi draw/resistance in the circit
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions