Questions & Answers for: Proform swing set

I have a model 297980 J8 proform treadmill. when I first start it up without the safety key in it, the treadmill runs at full speed for about 2 minuets. After that it slows down and stops. The speed ...

I have a Proform J8 treadmill. It is about 12 years old. After setting the speed, it changes to read 0.0 and speeds up faster than the speed it was set at. I have calibrated it a few times. Does it ...

Proform EKG Cross Trainer Treadmill-will not operate since it has been moved. When the speed is set, it will start at the set speed and immediately decrease until it stops. Also, the incline will not ...

Pro-form 990 cs won't turn on Is this a new machine for you? Are you sure the magnetic key is correctly in place. Also, check to see if there is a red re-set button near where the cord comes into the ...

...crank axles, then reattach the ends of the pedals. 2 Remove the bolts connecting the pedals to the swing arms. Detach the pedals from the arms, then spread a layer of machine grease over the axles

...set them aside. Examine the interior of the base unit and locate the drive belt. 3 Pull the drive belt free of the crank pulley, flywheel and any other pulleys. Discard the old drive belt and install ...

...crank axles, then reattach the ends of the pedals. 2 Remove the bolts connecting the pedals to the swing arms. Detach the pedals from the arms, then spread a layer of machine grease over the

...set them aside. Examine the interior of the base unit and locate the drive belt. 3 Pull the drive belt free of the crank pulley, flywheel and any other pulleys. Discard the old drive belt and install ...

Squeaking while running when set to a low incline. When the tread mill is set to a level 2 or 3 incline with every foot fall there is loud squeaking that seems to be coming from the hinges where it ...

my proform xp 800VF incline goes down after standing on it. Whenever I set the incline, the treadmill goes up to that incline and seems fine. The second I stand on the treadmill, the incline never ...