suds in the system and this affects the sensor and causes the drain pump to run and run and run until it shuts off from overheating. This is why we get the F2 and/or suds error code. Once a month, run
...suds (like using the wrong detergent), or an actual sensor problem. I followed online advice to pull the tube and blow back to clear any suds out, and that cleared it for one cycle, but then the ...
Question about MAH6700AWW Neptune Front-Load Washer
...suds. I believe these washers have a sud sensor in the pressure switch. either that or there maybe something in the pump. The metal sound would be the tub bearing going bad. Like i said, if you dont ...
...suds sensor which detects the presence of excessive soap suds. This can be solved by switching detergents to a phosphate free detergent. If this is what you are already using, then there could be a ...
Question about Duet GHW9150P Front Load Washer
Whirlpool Duet -Sud displays and washer stops I have a Whirlpool Duet Steam model WFW9600TW01. It has already had the main control panel board changed, now it is stopping just as water starts into the
...sensor failure. The SUD is normally displayed when there is excessive detergent suds in the tub. A loose wire harness connection could be causing this problem is there is no water or suds in the tub. ...
...sensor failure. The SUD is normally displayed when there is excessive detergent suds in the tub. Make sure you are only using the recommended amount of HE detergent. Then run the washer without ...
...sensor failure. The SUD is normally displayed when there is excessive detergent suds in the tub. Make sure you are only using the recommended amount of HE detergent. Then run the washer without ...
...-High current detected • 2E--High/low voltage detected • 8E--Vibration sensor problem • 7E--Silver Care control problem • SUdS--Too much suds detected during wash cycle, unit on hold until suds ...
Question about EPIC MFW9700S Front Load Washer
...by program or a timer. It will rinse the same way no matter how much detergent you put in. When you choose 2nd rinse it will do the same thing twice. There is no sensor just for rinsing suds
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions