subzero 642 refrig is hot and display says "vacuum condenser...how do I do this if you fridge runs for 6 cycles with out a cycle off .. your vacuum condenser light will come on. you can check the ...
hi, i have a subzero side by side fridge/freezer, not sure of the model#. the freezer has the regulator panel, with the temperature control wheel, in the middle of the freezer, separating top of ...
...642 about 5 years ago, and had to have the condenser coils replaced twice- because the refrigerant was leaking. warning signs are: temp is more than 37 degrees [ get a fridge thermometer to monitor], ...
Subzero 642 Ice maker issue Ice maker not making ice all the time. Seems that water is draining into the ice bin whcih causes a giant ice block to form. Do I have a lose drian hose? Or what is the ...
Question about Bottom Freezer Refrigerator
...Subzero 642 fridge lights have stopped working. they would flicker when i opened the door but now they don't light up at all(including the temperature display pad). the freezer is fine. Thanks for ...
642 Your display will not work unless your refrigerator lights work. 1st. Make sure your light bulbs are good.2nd. Check your refrigerator door light switch.3rd. The subzero uses a thermal overload to
Question about 642
Subzero 642. Ice maker froze up (3 inches of ice surrounded it). Repairman steamed it loose. He could not run diagnostics because Subzero Tech Support was closed for Easter holiday. Yesterday evening ...
SUBZERO 642 DRIP HOSE WATER LEAKING FROM REFRIGERATOR CLEAR DRAIN LINE, VERY COMMON PROBLEM - TRY TO PUT SOME TUBE INSIDE AND CLEAR EVERYTHING OUT OF THERE. I USE 1/4 " TUBE. HOPE IT HELPS
Question about 642
...subzero 642 side by side? Temperature on the refrigerator side can not be maintained. Service added refrigerant but told us to replace the evaporator. Is that our only alternative? Hi, Thank you for ...
Question about 642
...Subzero Model: 642/S-3 Ice formation on the top left corner front side in the freezer section of this side by side unit. Door seal ok & Level ok. door seal not ok --check level --alignment and hinges ...
Usually answered in minutes!
3,171 Questions
1,894 Questions
1,239 Questions
1,098 Questions
927 Questions