sub_2 -ve back to amp channel 1 -ve. NOTE: make sure that your amp can support this first! If it can't then it's will auto switch off in most cases but can also damage the amp if there is no fail safe
sub then you can wire the amp two channel and get 400 watts x 2 @ 4 ohms. Make sure that you sub can handle this kind of power though. Here are the specs: 4 x 100 @ 4 ohms (13.8V - <0.05% THD) 4 x 200
How do I add another amp and speakers to my system. I have 3 pre-outs (1 pre-out for subs, and one for four channel amp running front and rear speakers) I'd like to add another 2 channel amp and 2 ...
sub, and then the other. Your amplifier is a 2 channel amplifier rated at 60 Watt - 4 Ohm - 2 channel(s) 125 Watt - 2 Ohm - 2 channel(s) 250 Watt - 4 Ohm - 1 channel(s) Your amplifier is not rated for
...sub into the 1st positive channel on the amp and negative of the sub into the 1st negative channel. The same goes for my other channel on the amp. What load does this give me? And how would you wire ...
...channel amp into a single sub, am i just creating a mono signal, or is full power going to the speaker as well? Thank you Hello again jm129852, Having two power and ground terminals allows you to run ...
Question about Punch 801S Car Audio Amplifier
...sub 2. channel 2 to to sub three then straight to sub 4. Hello dreww1005, If your alternator and battery are in good condition, you probably don't need a capacitor. At maximum output, the 801S will ...
Question about P3001 Car Audio Amplifier
...sub to channel A or you can hook 1 4ohm subs to channel A and 1 4ohm sub to channel B. There 2ohm stable so any lower will eventualy burn the amp out. port A would be for the left sub and port B is ...
...channel 1 to sub 1 coil 1, + to + and - to -, then add a jumper from coil 1 to coil 2, + to + and another jumper - to -. Do the same thing with channel 2 to sub 2. OK? I would bridge down to to 2 ohm ...
How to bridge a 1 channel 1000 punch 55amp You can not bridge a 1 channel amp. Bridging is when you combine the output of a bridgeable two channel amp into one channel, typically to power a sub woofer
Usually answered in minutes!
87 Questions
58 Questions
47 Questions
26 Questions
21 Questions