Wiring I have a kenwood kac-9102D i was wondering how i should wire it for one single 12in DVC 4ohm sub. SHould i connect both positive and both negative speaker outputs to their respective places or ...
Question about Excelon KAC-X521 Car Audio Amplifier
...That channel has a blown fuse. have you tried running + and -, + and - to both channels to see if both subs worked? If one sub doesn't then it's a blown fuse or scarred fuse and needs to be
Question about Excelon KAC-X521 Car Audio Amplifier
...seem to be working.. Temporarly im running both subs off 1 channel and now my subs and toggle switch dont work! help wireing an amp can be tough it starts from the e.q.the e.q. must have a sub
...likely the RCA's are running from the sub out on the deck to the amp. You need to run two sets of RCA's for a 4 channel amp. One for the sub out and one to the front or rear channel. Hope this
...channel. Wire both positives and both negatives from both subs to the bridged connections and the output will be 150 watts into 4ohms. Giving each sub 75 watts should make them push a little
...sub to the - on the amp. NOTE IF YOUR AMP IS BRIGED THIS IS A 1 OHM LOAD!! IF THE TOO SUBS ARE ON ONE CHANNEL THIS IS A Two OHM LOAD IF YOU ARE RUNNING 8 OHM SUBS THEN YOUR AT 4OHM PER CHANNEL AND 2 ...
...sub to each channel, set the filter switch to the far right (LPF), set the operation switch to stereo (both channels driven), set the filter frequency (Hz) to 100 or lower, and adjust the input ...
...sub 1 is hooked up to channel 1 positive and channel 2 negative, and vice versa for the other sub. That'll dramatically increase the output. Again, make sure the amp documentation says it is 2-ohm ...
sub on the other side always does. The gains are set properly and as far as my knowledge goes everything else is hooked up correctly. What could be causing this? It may not be the box it could be that
Question about KFC-W2512 Car Speaker
...channel each sub having their own. I heard doing a series hook up and bridging the subs to the amp would give me a better sound. How would I go about that I'd this is the best method. Bridging an ...
Usually answered in minutes!
202 Questions
203 Questions
165 Questions
142 Questions
149 Questions