Questions & Answers for: sub channel

Ad

Question about Xplod XM-1652Z Car Audio Amplifier

1 Answer

...from two 2-ohm subs, each connected to a separate channel. That way each sub would be getting 200 watts RMS, still low but there's lots of good subs that will sound pretty loud with 150-200 ...

Ad

sub to a 4 channel amp. I want to wire 4 speakers and a sub to a 4 channel alpine. Whats the best way? Hello emscarboroug, You did not specify which Alpine 4-channel you have. If you have the MRP-F240

Ad

Question about Talkabout FRS 250 (14 Channels) 2-Way Radio

1 Answer

sub-channel on my pair of old Motorola TalkAbouts (no model number on units, no manual). I can get the channels to change, but not 'stick'. Can't get the sub-channels to change. I know they are on the

Question about Talkabout FRS 250 (14 Channels) 2-Way Radio

1 Answer

..."A" channel and 'B" channel on together. The back of the Denon should have two sets of speaker outputs. Connect the "B" channel speaker outputs to the sub. The "A" channel will still drive your

Question about ST4-720 SPL 4-Channel Power Amplifier (720 Watts Bridged Max) Car Audio Amplifier

1 Answer

...channel, the other coil to the other channel. single 2 ohm. dont use it unless you get another sub like what you have. then run it stereo. one sub to one channel. the other sub to the other

Question about Walkie Talkie 2-Way Radio

1 Answer

...sub-channel. Are the sub-channels for both radios the same? If not they need to be matching. The easiest way is to set them to "0". (You can read more about the sub-channels in your Motoral owners ...

Question about GM-X332 Car Audio Amplifier

1 Answer

power rating for this amp is as follows.Two channel: Sub woofer: Min 35WattsTwo channel: Other than sub woofer : 70WattsOne channel: sub woofer; 100WattsOne channel: other than sub woofer: 200Watts.OK

...you can bridge channels 3 and 4 to get increased power to your sub. You have a 4 channel amp - channel 1 and 2 go to your 3-way speakers up front, which leaves channel 3 and 4 available for your

Question about Nike PSC Communicate (14 Channels) 2-Way Radio

1 Answer

...Sub Channel (1-38) 3. Channel Scan (ON/OFF) 4. Sub Channel Scan (ON/OFF) 5. Button Confirmation Tone and Roger Beep ON/OFF) 6. Vox (OFF, ON LO, ON HI) (psc[communicate wxonly) When you have proceeded ...

Question about Nike PSC Communicate (14 Channels) 2-Way Radio

1 Answer

sub to either a or b channel outputs you may wish to use an rca splitter before the amp to feed both left and right audio channels into a single channel on the amp. WARNING connecting both channels on

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

The Knight
The Knight

Level 3 Expert

76204 Answers

Mark Skinner

Level 2 Expert

79 Answers

Are you a Car Audio & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...