Question about 12 cu. ft. / 340 liter Commercial Freezer T-12F
...setting, but it won't warm up. Any thoughts? thermostat is stuck closed, if not compressor relay is stuck closed, if not then the defrost timer is stuck closed. test the components in that
Question about T-49 Side by Side Refrigerator Commercial
...the freezer compartment and everything warming. We can hear a fan running - we're wondering if it's stuck in defrost mode? it would not be likely to stuck in defrost mode but my guess would be the ...
the fridge freeze the food My True fridge freeze the food The thermostat is probably stuck closed and bad. A good replacement would be a Ranco A12-1560. If its not the thermostat there may be a stuck ...
Question about TBB-3G-S Commercial Refrigerator
even at lowest setting and freezing drinks. The thermostat sounds like it is out of calibration and stuck closed. A good replacement would be a Ranco A12-1560 mounted in the evaporator (cold) coil
...the beer. is this a problem with the thermostat or something else? This is probably the thermostat stuck closed and bad. Turn the tstat all the way to left or counter clock wise. The compressor ...
treadmill doesnt want to start 1) LUBE the deck belt, maybe you have WORN deck belt by lack of lube and maintenance. 2) LUBE the rollers bearint you must do it after 5 hours of use. 3) Test the drive ...
Question about TS-72FG Stainless Steel Freezer 3 Glass Doors 72 cu ft
evap fans wont come on what to check for evap fans not coming on Check to see if the door switch is stuck open
Defrost timer stuck in ds2 needs to be replaced
Question about TS-72FG Stainless Steel Freezer 3 Glass Doors 72 cu ft
Door frames are very hot and unit seems to be stuck on defrost When a freezer is not working the door frame heaters don't know and just keep on heating as long as the unit is plugged in. As far as ...
Question about TS-72FG Stainless Steel Freezer 3 Glass Doors 72 cu ft
...after getting something inside; checked inside fan was running slow. Noise sound like something stuck in motor. Unplug unit overnight, plug in next morning set knob at 1, runs fine, cycle off ...
Usually answered in minutes!
39 Questions
34 Questions
27 Questions