when driving if you hit a small dip you feel a shunt in suspension but when you go over ramps its not so bad already replaced anti roll bar bushes and link bar and adjusted bearings and rear struts I ...
...(cheapest) but if you haven't rebuilt the front end (upper & lower ball joints, tie rods, strut brace bushings, etc...) you may have worn out busings, joints and other components. Look for ...
Question about 1997 Mercedes Benz S Class Coupe
i have a 97 s320 and i get a vibration between 50-55mph after that it smooths out The 1st thing to get looked at is the wheel balance.Have them checked.At the same time,if the tyres are o.k. have them
...I am trying to locate it on car so I can check it and the fan relay Try the fuse on the driver side strut mount first. Then the regulator underneath it and lube the bearings and turn by hand while ...
...so much for your great service! If you go to the auto parts store,the strut and the bearing plate will run close to 150 dollars each,and the bearing plate has a bearing in it to allow for
...strut mount in the black tootsie roll sized case. You must push it slightly as it can crack and cannot be easily seen. If its not that there is a regulator mounted under the motr, the motor brushes ...
banging on bumps Many number of things, bad shocks, bad struts, bad ball joint, suspension drag links, body mounts to rear end, carrier bearing for drive shaft, or even drive shaft flex disks. You ...
this is probably your noise. It's not hard to remove the strut, three nuts on top and two bolts on bottom, but you will need a coil spring depressor to remove the bearing plate at the top of the strut
what kind of service at 120000 miles All of the following: Change all fluids including coolant, brake fluid, power steering fluid, transmission fluid, and crankcase oil. I would strongly recommend ...
Usually answered in minutes!
630 Questions
563 Questions
615 Questions
474 Questions
420 Questions