...wrench in there. The new starter will come with shims, thin strips of metal. These are for getting the right distance between the starter gear and the flywheel. Hopefully you won't need them. But if ...
...strap that has a 1/2 inch bolt and the filter itself requires a 13/16 wrencha dn a 5/8 line wrench when taking it apart. The line coming in from the trank side has the push on connector that you need ...
bolt off of the crankshaft balancer to replace Hold the crankshaft from turning with a chainwrench or strap wrench.Remove the crankshaft damper bolt on the usual direction,torque to the specifications
...road master cant get the gas out of tank so we can drop it The fuel line fittings and the tank straps are probably rusted at the threaded bolt and nut. Have some penetrating oil spray onto them ...
...strap mounting bolts and tighten to 35 ft. lbs. (47 Nm). Remove the jack. Connect the fuel return pipe to the fuel feed pipe. Attach the rear fuel feed pipe to the inlet side of the fuel filter. ...
...that runs from the battery to the body. Make sure its clean, shiny and tight. There is a ground strap from the back of the motor to the firewall. It needs to be there and clean as well. Follow ...
...strap wrench to hold balancer pulley in place while removing and re-installing balancer to crankshaft bolt. (helper required) Procedure for replacement: Remove negative battery cable. Set parking ...
Question about 1994 LeSabre
a strap wrench on the balancer or pulley if the belts are removed. If the belts are on and are tight, try to wedge something between the belt and pulley as you start to loosen the bolt.Good luck
...wrench remover set. They are large skinny wrenches that hold the bolts on the fan so it doesn't spin, while loosening that large nut. Sometimes you can monkey around with strap wrenches and ...
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
1,091 Questions
904 Questions