Questions & Answers for: All-Pro stops

space runs 15 seconds then stop i push the reset button and starts , then stops check in front of the flame there should be a flame proving rod which may be dirty, use steel wool to clean it so it can

Flame ignites for several seconds and then stops there is a flame rod that looks like a thermocouple. Clean it with a pencil eraser or scotch brite pad. The carbon build up on it acts as an insulator ...

will not run unless shroud is lifted up about a half inch in the front. Is it stopping the fan from coming on? If this is the case make sure the fan assembly is seated correctly in the base

Hi there, my forced air kerosene heater works ok for about 5min and stop. You can turn off and turn on again, and it will start over and stop after. What's going with it? Hi, Here are a couple of tips

...a 170t all pro heater when i start it the hot surface ignitor comes on the fan starts then it all stops and the flame light comes on check out the presure switch could be blocked, or try jumping it ...

Have a Dyno-Glo Pro heater burning GASOLINE in a 2 car garage w/ a CAR & numerous other things in it. the Carbon Mon smell comes in the house - person WILL NOT LISTEN to how dangerous I think this

heater runs for 3min and stops water in kerosen

sears 30,000 but heater will not stay running.Rnus for about 2 mins then stops. runs for mabybe 2.mins then kicks off. Click the link below ...

I turn it on and you hear it running than it stops. Make sure the sparker and flame detector are clean and properly adjusted. Also, make sure the fuel is fresh and moisture free.

spraying fuel out the front. stopped by the job and the floor in front of the heater was soaked with fuel. pressure to high turn down to 8.5 or 9 at least the mr heaters run at that for that size ...