...power is applied. The transient spikes found during actual use by switching sources is only handled by top end equipment and it's built into the unit. Use of a .01μF or .022μF 250VAC ...
...power off. Also, it only thumps once I turn up the gain, otherwise there is no sound coming from the sub. I am pretty sure its not my receiver. It must be the sub. Is my sub destroyed? thanks for the ...
...Amp! Power Acoustik PS2-1200 I've had a full audio system in my car for the past three years, including 1 two channel Power Acoustik amp that has recently stopped working. The power led is always ...
...amp punches the bass, it draws extra power. If that power isn't available, it starves and shuts down (if only for a second) then restarts. The higher the gain, especially using a low pass filter, the ...
Question about HK4000D Car Audio Amplifier
power wire and 6 gauge ground the amp b4 this was the mtx 8100d ya far cry from this one but never had this problem b4 help plz... and help or question email me plz ..11/23/08 [email protected]
...power and resistance you can just connect any old subs to a system you need to wire them depending on the load that the amp needs to see. first thing is to try the amp/s on a individual sub to check ...
...your description it sounds like the amp is "clipping", so my gut tells me it's more of a power problem. Recheck all your wiring. If you have a multimeter to check your power, use it. Good
Question about 5.1-Channel Home Theater Speaker System with 150W Subwoofer
...power came back on , the subwoofer immediately started making loud thumping noises. I had to unplug it or turn it off to stop it. It also doesn't seem to be working, Anything I can do or just buy ...
Question about 5.1-Channel Home Theater Speaker System with 150W Subwoofer
...amp Yes to what brenda says but as well as a cheap set of rca cables will do the same thing and also dont run any power wires or remote wires next to rca cables or speaker wires this will cause "road ...
Question about Xr 8600 8 Channel Powered Mixer
...amp stopped working although all led's and lights were working on the mixer does the speaker still work? use a 9 volt battery and do a test thump to see if the horn and woofer still work...when the ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions