Questions & Answers for: Precor stop errors

Precor 9.25i Treamill scrolls message "button is pressed" My Precor treadmill will not stop scrolling "button is pressed" message. I have replaced the touchpad consol and it still does it. I even ...

the treadmill stop when i increase the speed and t... The treadmill stop when i increase the speed and the error 26 show Error 26 is what's known as a Motor Pulse Width Incorrect. It basically ...

Error code 05 appeared on screen. We have tried to reset. Hit stop, enter, & quickstart buttons as decscribed. We also tried the reset button. The error code remains. We unplugged and tried again,

C956i Precor is displaying Error code 44 ? Treatmill stopped running. Precor Error 44, Un-commanded Lift Motion Probable Cause 1. Intermittent or bad connection in the lift position ...

...errors on the unit, you can press and hold the stop button for 3-5 seconds and it will go into the error log. Not sure what model you have.E-2 is not what normally shows up on the screen. Do you mean ...

...and started the treadmill. I was checking the belt alignment at approx 7 mph when the treadmill stopped. Now every time I try to start it I get the belt error. I removed the drive belt from the ...

Precore 9.35 Error 5 My Precore 9.35 stops within a few seconds of running after attaching the security clip. Panel states Error 5. I can restart it manually but cannot attach the clip without ...

Precor 9.35 Error 5 My Precor 9.35 treadmill displays an Error 5 after attaching the safety clip and running for a few seconds, then stops. I can restart it manually but cannot attach the clip without

...High Error 29, Excessive AC Input Current Error 30, 31, 32 and 33, Communications Error Error 37, E-Stop Not Working Error 40, No Lift Motion Detected Error 41, Lift has not Responded in Acceptable ...

...errors, just very fast operation. I recently moved it and had to unplug the upper control from the lower PCA. I can lower the setpoint to .5mph and it will stop. I did a diagnostic and in the ...