...change the whole board.) part number on the chip where the metal heat sink is located. Part number may be STK 730-010 or STK 730-130 both number will work and must be unsoldered and new soldered
Question about R52WM24 52" HDTV Projection Television
...Go to this website I posted and e-mail them with your model and trouble they can tell you what STK chips you need because you will need to replace them to correct this they also have online free ...
Question about D52W20 52" Rear Projection HDTV-Ready Television
...glasses on. Please help, thanks for your assitance. Replace 2 convergence chips, will start with stk
...are easy to spot. They are mounted to large, finned heat sinks. The # on the chips starts with "STK-" and then there are numbers following. Both red and blue use the same part. There are 20 or so ...
STK #'s of the chip or chips inside ( big heat sinks)these are the conversion IC's then there will be some resistors to replace and thats about it except the convergence settings on the tv remote then
...happened last night while I was watching TV... Do you have a possible solution? Thanks! Nahomy Diaz converge power supply small pcb about 3 inch by 7 inch with stk-730-xxx chip on it ..replace the ...
Question about P60921 60" Rear Projection Television
...collaborate the cross hairs or, even out the rgb, this will confirm convergence board failuer. the chip set on this board is faulty. Replacing the convergence board or stk chips will fix this
Question about P61960 61" Rear Projection Television
...look to it. How do I locate the IC chip to determine the STK number? Thanks! This model does not use STK CHIPS. Look on back of set where model number is---what is PTK number---ie: PTK 169, OR PTK ...
...STK ic chip mounted on a metal heatsink. If you have to call a repairman to do this a reasonable price would be 250 depending on the price of in-home visit. Fairly simple repair on this model. Good ...
Question about D52W20 52" Rear Projection HDTV-Ready Television
I have an apex model, GB65HD09W with convergence problems. I have already replaced both stk 392-020 chips Is ther a fuse or resister feeding the B= to the chips? I checked all the resisterts in the ...
Usually answered in minutes!
2,410 Questions
1,124 Questions
809 Questions
789 Questions
510 Questions