Questions & Answers for: stihl saw ts400 spark

stihl saw TS400 will not get fuel through,NON START stihl saw TS400 will not get fuel through,I have changed carb diaphragm,there is a good spark but will not start. how much fuel can be put into a ...

...a new carb kit to my stihl ts400 also new piston,rings,barrel,plug and all filters and still will not run has good spark but also has strong kick back for some reason Are you using new fresh fuel

Stihl ts400 no spark I have a ts400 saw with no/very weak spark. If I motor the engine with a drill then it sparks but I think that it is too weak to jump the plug (new) gap under compression. It ...

...stihl ts400 problem, my saw wont start, it starts with every pull but only for one cycle, gave new filters sparkplug, checked compresion and so on and its same, just cant fix it, plug comes out wet ...

Stihl TS400 stone cutter not working (no compression) so replaced piston rings, new gasket kit and clean for carb new spark plug (good spark when engin turned over) cleaned all air filters, replaced ...

no fuel to spark plug stihl ts400 new plug,valve,good spark but plug is almost dry when pulled is this just a blockage or is it the carb? could be fuel pipe bent/hole in fuel pipe or yes could be carb

saw has compession fuel and spark but will not start You might check the air filter to make sure it's clean. Also make sure the kill switch is in the on position.

saw w new cyl., piston and rings, carb, and decomp valve. The orig ign module had no fire, replaced w aftermarket? Oem stihl is $175! Any help or tips will be appreciated. Is cutomers and have $400 in

Stihl saw ts400 floods straight away, choke up as always if I remove spark it's soaking then leave a while and will start. Once it's been started it will continue to start fine and idle fine Good for ...

What set spark plug at Ts400 stihl concrete saw Most Stihl machines use 0.5mm spark gap