Questions & Answers for: stiff choke

...Stiff usually means good compression. So, pump the fuel bulb, put your foot on the flat in the handle, lock the throttle open using the button on top, set choke all the way out and pull. It should ...

...indicates a choke stuck in the open position. Also, you may need to look for a vacuum leak if cleaning it doesn't fix it. On a 1981 GM product, I'd expect the vacuum hoses to be stiff and

...choke. what is the problem? Is it gas problem? It may be bad gas. The only way to know is mix up some fresh fuel mixture. Get as much of the old gas out of the trimmer and put the fresh in. It may ...

...choke or start. 3. Press primer bulb 4-5 times, until it gets stiff and feels full. 4. Pull cord until the unit starts or at least sputters. 5. Put the choke lever to the 1/2 way point and pull rope ...

2006 katana choke stiff should be the same as on my gsxr spring could be tight on the lower end of the cable which is located right nest to the left hand foot rest try spraying a bit of wd40 on it

choke on and it runs. The cause of this in most gas engines is a plugged jet in the carb.  It must be taken apart and thoroghly cleaned.  The jet must be unplugged with a stiff wire or paper

...down when i rev it POSSIBLY (if present - happened to me on a different bike) a mechanical link between choke and throttle got stiff so 'choke' (the 'a bit more throttle' component) kept the revs

choke is stiff when you engage it on start up where it wasn't before. In fact the transition was smooth and it isn't now. The engine is running far too fast and using far too much petrol. the throttle

...choke. That's is a lean fuel condition. Start by being sure you have good fresh fuel with a high quality mix and no water. Then check fuel lines and filter, replace if discolored or stiff. Then ...

...choke. I actually say that because manual chokes in a place like Michigan will get stiff, rusty or freeze without proper maintenance and shielding. I lived in Alaska and Cheyenne Wyoming and noticed ...