Questions & Answers for: Kenmore sticky dial

...dial over to continue the to the spin cycle. Thanks, Jason seems the timer knob is old and need of replacement normally happens due to age as the timer switches inside the timer knob become old and ...

kenmore washer dial not working kenmore washing machine model #110.82980120 - dial that you turn to start wash cycle does not reliably turn. It clicks a little then stops and spins. Do I just need to ...

The manual does not say what the dials are for on the top right side of the unit under filter. What is the purpose of this 2 digit dial? Kenmore 85244 Air Purifier Air Purifier The manual does not say

Kenmore 80 series washer wont drain or spin. It goes through the agitation cycle and when its time to drain it just stops. I maually advance the dial by pressing on the outer ring of the dial while ...

Kenmore Heavy Duty Series 70 washing machine gets stuck in cycle. We have a Kenmore Heavy Duty Series 70 washing machine: It will fill and agitate in the wash cycle, but keeps agitating until I ...

...on this model, but the switches are usually at the bottom. Door switches are notorious for getting sticky. Lots of things get spilled in the fridge and run down to the switch. If the switch doesn't ...

...cycle but now it does not drain. Any suggestions? It sounds like a problem with the timer mechanism itself. Make sure there is nothing restricting the dial from turning (sticky gunk behind it,

...fell into lint trap...how do i get it out? Can you see it? A trick I often use is to find some very sticky tape securely attached with the sticky side out on the end of a stick, and try to touch the ...

How do I remove the sticky residue from a label placed on the outside of my new refrigerator without damaging the finish? I cannot remove the sticky residue left by a label placed on the outside of my

Kenmore Washer 600 Series SM9711916 Washer has four water temperature settings on the dial (Cold, Cool, Warm and Hot). Also, a note under the dial states "All Cold Rinses". When the dial is set to ...