...will show step by ste; Thanks for the support. Now that I know the board is gone would anyone know where I can find step by step instructions on replacing it. Also where can I purchase a board ...
...step onto the board until it has calibrated (this is when the board establishes its zero point). It will clearly say "Starting Up" followed by "Ok, Step On." After this, you can generally stay on the ...
...step on The wii board will not let you step on because every time it says "please, step off and press a." when you step off it says that the wii weights anywhere between 12-14 pounds... help anyone? ...
Question about CTA Digital WI-BBP Wii Fit Balance Board Battery Pack
...ejecting the disk and starting over again. It didn't help. You need to load it, stand on the board, step off, and then press A. I have a WiiFit and that happens. It expects you to be standing on
Question about CTA Digital WI-BBP Wii Fit Balance Board Battery Pack
...by washing with spirit/thinner, and heat it with the blower. Step 7: Make sure the board is cool before you couple it back. Step 8: If no network still, you have to rewrite the PM by using a
Question about CTA Digital WI-BBP Wii Fit Balance Board Battery Pack
...board. Second, repeat first step above. If there are no flashing light on knocking area,. that problem from inverter board. Replace it. If any problem and questions, please let me know. I hope that ...
...step aerobics. I've re-sync'ed the board several times and actually tried another board but the problem has persisted. It's not due to stepping too quickly as I'm on "the beat" even at ...
step replace inverter board Can you give me step-by-step instructions to replace the inverter board. I already have the unit off the wall and the outer metal cover off the microwave. I think I see the
...board charger Need step by step instructions on how to replace the on board charger to an off board charger. Not an easy job. There are parts that need to be installed on the scooter and wiring ...
...step 4. 4 On the Engine Control Board, check P/J2 at pins 1, 5, and 7 for +24V. Are the voltages present? Go to step 5. Go to step 6. 5 Replace the Engine Control Board. Does the problem persist? Go ...
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions