2 wire terminals on the switch and see if the meter shows continuity or the light come on. Step on the brake, it should change.I believe the switch is part of the brake line, so the whole thing has to
...step proceedure to remove rear fender from 2000 fxdwg 1. Follow the taillight and rear turn signal wire harness to the 8-pin connector under the seat. Separate the connector. Remove the seven wires ...
the codes out of it or have an idea what is causing this? To Get the codes you need to follow these steps: 1. While holding the odometer reset switch in Turn the ignition swithch to IGN. Make sure Run
...Step 2: Press left turn signal 2 times and release confirmation: 2 or 3 flashes on turn signals (depending on configuration) 2 for USA, 3 for everything else Step 3: Press and hold key fob button ...
...OFF the ignition switch. Run your bike and shut it down then recheck the DTC's again by repeating steps 1 to 3 If the code is current it will reappear. 4 - Press and release the odometer reset ...
Question about 2010 FXDWG Dyna Wide Glide
...2. Inspect the bulb socket for corrosion and clean as necessary, a spray can of electrical contact cleaner and compressed air works the best. 3. Confirm your test light is working properly by ...
Question about 2000 FXDWG Dyna Wide Glide
...it will not idle unless the choke is full-on and run poorly then stall, here are the following steps necessary to complete in order to get your bike back to an acceptable running condition and
step 2. b. If gauge did not indicate FULL, proceed to step 3. 2. Set MULTI-METER to resistance scale to measure the resistance of the sending unit. Place one probe on Y/W and the other probe on a good
Usually answered in minutes!
230 Questions
114 Questions
107 Questions
104 Questions
30 Questions