...AF lenses but I am unable to control this problem. I am not in favor of sending camera back to Pentax yet as I don't like what I am hearing regarding Pentax service in the states. Anyone seen this ...
...filter and unplug the unit, then plug unit back in and code will be reset. However, a User review stated that his code was not reset until he followed a fairly simple routine. "Unplug the unit.
reset air conditioner air conditioner keeps shutting off leaving an E1 message Unplug it. Wait a few minutes. Hold in the Power button while plugging it back in and keep the button held down until a ...
...code for incorrect readings (dirty) in the MAF. Cleaning it always helps, and cuts off the light. Your acceleration problem may be either a wrong Air-Fuel sensor (the one before the cat), or an ...
Question about AF 70-300mm f/4.0-5.6 DL Macro Super Lens for Canon-EOS
I´ve been trying to use my Quantaray 70-300 mm lenses with my Canon EOS 450D. It gave me Err01 message (communication fault), I cleaned the lenses and it started taking the pictures but one at a ...
...code ##345 Short fix: 1.Take apart and wash the ink clogged mechanical parts. Use hot water. 2. Reset waste ink counter Long fix: The following operation takes several hours / days to complete. -Take ...
...code PO351 I replaced both coils,changed old Distributor cap and rotor (they needed it.) Problem remains but only did it once sense yesterday,happened early this am 1 time engine was 150 degrees ...
...state rated 180F or higher, never run 160s ever in any EFI is the check engine light on? if yes, and the code 6 is set, that means the ECT is dead. and guess what if that's dead so most the RAD ...
Question about 1996 Grand Cherokee
...AF is dirty) is called a MAP sensor on GM cars (not sure if it's the called same thing on other makes) should indicate an error code (or a fault). This fault can be read by a code reader connected to ...
Question about 1996 Grand Cherokee
...code light might return after a few miles of driving. State Inspection requires that all monitors are ready during emissions testing, so make sure that you have completed a drive cycle (about 3 days ...
Usually answered in minutes!
1,383 Questions
1,133 Questions
959 Questions
944 Questions
808 Questions