...slow to crank and I have to tap it with a wrench to get it to disengage.Does that mean my starter is shot? no that does not mean the starter is shot. the only way the start can be energized is by the ...
slow on electrical side, i need help on two solve this issue. thanks in advance jack The starter is not disengaging back. When you start the car the end of the starter pushes out, then retracts again.
Question about 2000 Jetta TDI
...starter is slow to disengage , but I would check with someone who is handy with cars , not necessarily a mechanic , just someone who can confirm your assessment and my suspicion. If that's the case , ...
Question about 17.5 hp 42 in. Deck Lawn Tractor - CA Model
starter? Does the engine happen to turn slower than before when you try to start it? A bent crank shaft can cause it to turn slower, and if it turns too slow, the compression release (if equipped) may
...starter motor, and disengages the pinion. To prevent prolonged overrun, the ignition switch should be immediately released upon engine start-up. See Figures 1 and 2 Fig. Fig. 1: Electrical system ...
Question about 1994 Metro
...slow turnovers lately but will start eventually. The starter seems to pull more amps lately and first turnover sounds labored but after the first turnover the starter cranks over with no problem. Now ...
...slow like something is catching on every second rotation. I just burned out and replaced one starter because of the hang. if its a briggs and stratton single cylinder... adjust your valves if not... ...
...slow. I had the starter tested and it shows to be good. Where should I start next? A side note, the tractor will not roll at all, and none of the hydrolic levers will move either. your hydraulics ...
Question about 1994 Metro
...starter checked its o.k,changed solenoid 2yrs ago,battery checked ok at a auto parts store(also swapped batteries as a why isn't it starting, could it be a ground problem? What does it act like when ...
...Slow - SAFETY - No children within 10 feet/ Pull Starter rope...... Repeat 3 - 5 times only. If engine starts, release choke as required until engine runs smoothly. If no start, - set Choke to OFF, ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions