Questions & Answers for: starter handle

Pull starter handle is locked in it's orginal position,pulling on the handle does nothing Unless the starter rope jumped track and is causing the problem, it sounds like the engine is locked up.

starter handle and try starter. If the starter handle does not come up tight to housing reclaim the loop with needle nose and give the pulley one or two more winds and try again until handle is pulled

...Battery good. Sounds like a starter. next time it does it try to tap on starter with screw driver handle or hammer handle just a couple taps then try to restart car if starts then starter is

...starter handle, 4: Pull the starter handle with your right hand and pull out the starter cord slowly until you feel a resistance (as the starter pawls engage) then pull firmly and rapidly until the ...

...glide and the starter is engaging when the switch is on Do you remove the handle bar recently, then check your starter button maybe the wire was pinched between handle bar and the switch

...four windings and the t-handle isn't held against the housing or you get more that four windings, shorten the rope at the t-handle.10. Reinstall the starter and you will be back in

...the upper handle and slowly pulled the starter cable. It will only come out about 6in then it get stuck. you need to install the cable and safety handle first hold down the handle then it will pull ...

...handle, pull it back towards the rear of the saw, this may take some force. If the starter grip or handle will not pull out then your saw may be seized or something is wrong with the starter its

...which is coded. after the door handles were replaced I attempted to drive my car home however the starter will not engage after turning my key. I know that the starter is brand new because I ...

...had door handles replaced. Not car won't even attempt to start. battery, ignition, ignition switch, starter, spark plugs, spark plug boots are all brand new. the key has a battery which is also in ...