failure occurred while the dryer was running. Press START to continue the cycle, or press PAUSE/CANCEL to clear the display. F-01 Primary Control Failure ?F-01? flashes when there is a primary control
Question about Neptune MDE5500AY Electric Dryer
...start/cancel option is not showing any effect. The touch pad has been changed a month ago when the original one has gone bad. I am wondering if this is another touch pad failure. Any help would be ...
...failure occurred during the current cycle. Press start/pause to continue this cycle" When OK is pressed it does the same thing. Try unplugging the unit for 5 minutes and let the control panel
Question about Neptune MAH5500B Front Load Washer
washer starts to fill, door dose not lock, washer dose not start to tumble, washer turns off after 20 seconds. most common problem is door switch failure or main board failure
Question about Neptune FAV6800AW Top Load Washer
Neptune FAV6800AW Top Load Washer: machine starts to spin, stops, starts againe, over... Machine starts to spin stops starts againe over and over then beeps twice and has code "dc" From what you are ...
Question about Neptune MDE5500AY Electric Dryer
...appearing "power failure occurred error message appearing "power failure occurred during current cycle". Dryer not starting Push the Start/Stop button on the Neptune to reset the
...start button until the appliance starts. Note: If the Hard Reset does not work, there may be an internal failure with the washer, that requires service. Hope this helps (remember to rate this
...and pressing and holding the start button until the appliance starts. Note: If the Hard Reset does not work, there may be an internal failure with the washer, that requires service. Hope this
Question about EPIC MFW9700S Front Load Washer
...dryer center MCE80000AYWHow HOW to fix bottom unit power failure when press to start. I need to start my bottom dryer unit which shows PF when I press the start button PF stands for "power
Question about EPIC MFW9700S Front Load Washer
start/pause is pushed the message says power failure occurred and the tub starts but just rotates only about a half inch hi it says power failure after it has turned by half an inch that because there
Usually answered in minutes!
1,743 Questions
867 Questions
815 Questions
489 Questions
196 Questions