standby mode via the remote Wait until No Disc is indicated on the fascia Now press Pause followed by 3, 4, 2, 2, 9 and then 2 The display should now read CODE Now press 0, 0 for region free or 0 then
Standby mode A little while back, the system went into standby mode & now it won't return to "pwer up" mode. CDs are getting stuck. I have to unplug the system from the wall outlet & wait a while - as
standby mode in the prolonged absence of a signal. Then they wake up when you play something. Or are you saying you need to Enable the Sub, as in setup? Remote probably required for anything like that
...standby light shows that protection mode is activated in receiver because of some problem in output amplifier section. Please check output amplifier section and replace defective component to fix the ...
...standby mode with out remote Switch off the power and then power the set using the main switch depressing the main switch to reset . Now pressing the program selection on the front panel will restore ...
...standby mode,no display aiwa nsz-20hr set doesn't get on. stays on standby mode.when power key is pressed relay doesn't switch on. it only gives click for a second. when on standby ...
Standby. Model AIWA CX-NAJ80: This player was working and suddenly just stopped. Everything is dark on the displays except for the red light above the power button. The light will flicker when I press
...going on standy by mode whnever i press the power button the standby light blink and i hear the releay and nothing happens what should i do please help mee do have the the circuit book of aiwa nsx ...
Usually answered in minutes!
48 Questions
25 Questions
24 Questions
21 Questions
12 Questions
