button on the TV itself, the green light will blink a few times but wont turn on the TV.any suggestions? I'm not 100% sure of my model but here is a link to the way it looks ( like this exactly) http:
...button in the remote to make the Tv go from standby to ON. A clicking noise means one of the boards is shorting out. In your case, I don't think you'd hear a shorting out clicking noise, and I think ...
...standby mode normally, then shuts down. It's going into a protect mode. The amp is probably shorted out. Disconnect the spkrs and turn it on. If it still shuts off, it's the amp, if not, it's the ...
...standby mode then holding the menu button and browseing through with the right side knob to the aux option and turn it on, defalt its not on you have to set it up, thank you juvie no its not, I used ...
button should be pressed in is you are only using one set up speakers. If you are running two sets of speakers from the same front channel then press in both buttons. If this does not fix your problem
...standby led is lit)and the error occurs, than I can't turn it on with any button. I have to replace the power cord. The problem appears sporadical. From about a few hours to a few days. Another ...
...STANDBY/ON button; "Clear" should be displayed; unit will revert to Standby mode. For a firmware problem, you can always have it updated. Pls reference this page for additional insights. Should it be ...
Standby ON. 2/- Press TIMER button & see TIMER at left corner of screen with AM12:00. 3/- Press and hold Standby until Screen comes ON & Standby goes OFF. Everything will get started from here
...standby button.. i unplugged it then plugged it back in turned it on ..then it turned right back off less then a second .iv had it for 2 years didnt have problems tell now .. if u could help that ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions