Questions & Answers for: Kymco stand by

t-clocs what does it stand for? tires control lights oil, chassis, stands,,,

...that bike is properly positioned. Is bike on level ground? With most bikes oil is checked on center stand or holding bike upright not on side stand. Also check manual some bikes say to check hot very ...

...because im lost. thanks steve Chances are it is a grounded kill switch on the handlebars or a side-stand / center-stand kill switch that has gone bad or is out of position. Stick in a new spark plug ...

quits. It has very low mileage. Either the clutch plates are stuck together (unlikely) or your side stand cut out switch or your clutch lever switch (on handlebar lever if fitted) is faulty Hi its the

engine starts when put in gear it stalls check the switch on the stand may not be opening. normally if you leave the stand down it will cut the engine when you put it in gear, its a safety switch.

2007 kymco xciting 500 drips oil near kick stand I have noticed lately that after riding the bike and leaving it sit for awhile, there is a small puddle of oil on the ground in the vacinity of the ...

were is the fuil filtter bike stolls when it is on it stand some bikes/scooters are fitted with safety device an engine cut off when on the side stand, look at the side stand the may be what looks ...

nothing happens do i need a new starter check for broken wires or lose wire on brake connectors and stand switch and battery voltage should be 12.7 volts

cant get replacement center stand for hipster 125 would any other bike stand fit hope someone can help thankyou Also would any other header pipe fit thankyou http://www.solanocycle.com/--kymco-parts

Cannot get my 2006 kymco scooter to crank over after dropping on right side i can jump it across the solenoid & it will crank & start check for a damaged micro switch for the stand unit