Questions & Answers for: Plymouth stalls when hot

Ad then rpms go up and the engine stalls it starts back but runs very rough and stalls again . vaccum port near throttle plate when you plug this port off partialy the engine will stay running good ...


Question about 1996 Grand Voyager

1 Answer

My plymouth voyager stall cold or hot. My Plymouth voyager stall cold or hot changed the emc, fuel pump, coil pack. Starts right up some time or will take up to 30 min. Once was running find stopped ...

Ad Seems to run okay at highway speeds but starts to cut out here and there when travelling at slower speeds, stalls once and a while when slowed right down at an intersection. Problem is ... and i slow down it stalls and won't start again til it cools down hours later all my vacum hoses are attached what is wrong? Change the coolant sensor but make sure the coolant is full up in the ...

My car will start and run for about 1/2 hr then it will chug and stall. It will not start again until it sits for about 1 hr. Added fuel injector cleaner but problem still there. I can hear the fuel ...

...HOT AFTER 100 MILES THE ENGINE STALLS, IF I LEAVE THE REST RESTART IT BUT 30 MINUTES 15 MINUTES LATER HE HOLD AGAIN Not clear on the issue.   If the engine is stopping when hot, you will ...

...stalls at stop and turns. hesitates some when accelerating from a stop. no difference when it's cold or hot. replaced tps. fuel pump and filter already not necessarily related. could this be ...

Question about 1999 Breeze

1 Answer stalls let it sit for a few and starts right up gets hot and dies Change the thermostat in it, You over heat it real bad ,There a chance of the motor seazing up, Allso is the water pump working, ...

...after it stalls. If no spark on any of the plug wires, suspect the crankshaft position sensor or the ignition control module. Either one can cause those symptoms- failing after it gets warm or

stalls when it gets hot. I found that my fuel pressure regulator was leaking so I replaced it, also my car had a code 26 so I replaced the injector and no more code 26. I also replace the fuel filter.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides