...SRC button down on the actual projector for an extended time. Then after letting it up, hit it briefly one or two times until it finds a source. Make sure that under Projector Setup/Management/ "Auto ...
...Select" is enabled in the Management Menu (buttons-Proj/Setup then >/9) and "tap" the "SRC" button on the projector itself to manually initiate the input/source selection. Verify that you have done ...
...src button on the actual projector. You may have to press it a couple of times. This allows you to manually search the source,(dvd,cable etc.) Instead of it doing it itself. Well I was hunting for a ...
...Select" is enabled in the Management Menu (buttons-Proj/Setup then >/9) and "tap" the "SRC" button on the projector itself to manually initiate the input/source selection. Verify that you have done ...
Question about Cinego D-1000 Multimedia Projector
...Select" is enabled in the Management Menu (buttons-Proj/Setup then >/9) and "tap" the "SRC" button on the projector itself to manually initiate the input/source selection. Hope this be of some ...
..."AutoRun" popped up. I then selected it and had the options of Acrobat reader, Driver, Manual, Src, and Menu Exe. It's just that when I click on any of these, A message tells me: Cannot open ...
...search. To turn it off, you should do the following: Through Limit Search: Press PROG, then LIMIT (SRC). Lo and 29.000 MHz appear. 29.000 MHz is the low end of the scanner's range. Enter the ...
...select source enabled. I press the SRC button, it searches for a minute or two, then defaults back to DVD. I have a presentation on Thursday. Please help. have you enabled the second display in ...
Usually answered in minutes!