Question about Motorcycles
wind the spring on kick starter Have a Yamaha Xt 350 would like to know if you need to wind the spring on the kick start shaft or is my spring need repalced? It doesn't take much to put it in the slot
...spring in re-wind starter. with no tension on spring install your pull rope. leave a loop between the pulley and grommet in housing. there is a notch in the pulley, locate the rope coming out of the ...
Question about P3416 16Inch 34cc 2Cycle Gas Powered Chain Saw
...wind the spring CCW until the spool assembly can be attached to the outer spring, then continue to wind the spool until the spring is about half-tight or so. It must be able to wind about three or ...
Question about CS330T 14" Bar Length Chain Saw
while repairing broken starter rope rewind spring popped out. need instructions to rewind and reinstall. judy Re winding starter springs is a real black art, and not for the faint hearted, always wear
Question about CS330T 14" Bar Length Chain Saw
wind the spring. It probably takes about 5 extra turns on the pulley to get the recoil tension right. Always hold the pulley in place to prevent the spring from jumping out. Release the cord so it can
Question about CS330T 14" Bar Length Chain Saw
wind the spring. It probably takes about 5 extra turns on the pulley to get the recoil tension right. Always hold the pulley in place to prevent the spring from jumping out. Release the cord so it can
...wind up spring, but most newer models have an enclosed spring.you should see a hole in the side for the pull rope. Insert the rope through the outer sheild first and thenthen in theslot of the ...
Question about CS330T 14" Bar Length Chain Saw
...through the pull start hole wind it clock wise it will attach to the pully and wind it up if you have a spring cartige you have to wind by hand and put it in the catrige wind in the direction of ...
Question about CS330T 14" Bar Length Chain Saw
...wind the spring. Once the spring has been at least 1/2 way wound up or tensioned, wrap the pull rope around the spool. When you assemble it and pull the cord, the spring should wind up further to its ...
...wind the clock now its normally the clock will stop on some time if one winding spring become to wide in and the spring cannot no more wider stretched. ALWAYS USE both winding springs, can remove ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions