Questions & Answers for: spinning tap Dryers

...go into spin. The machine rinses and then just sits there as if it is waiting on a signal to begin spinning. Once the time period for the spin cycle completes the washer then stops. What should I ...

...spinning with 9 minutes left on the cycle and gives me error codes IE or UE. IE: ? Water supply is not adequate in area. ? Water supply taps are not completely open. ? Water inlet hose is bent. ? The ...

my fan inside run only 5second the ciruits board been change out speed taps move to another tap it run through a cycle then when it come back it only run 5 second i need help ? Shut the power off to ...

starter spins but won't engage engine Try giving it a light tap with hammer if poss... you need to have in rebuilt or i suggest give it a tap with a hammer and then try it but u will need a starter ...

...2ft in the air if the tail spins to the right tap the left trim button a few times and if its spinning left tap the right button a few times and this should stop it spinning it works ok on my ...

where is the number one plug wire go at on the distruber cap Sometimes the cap is marked #1. sometimes not, inoder to find # 1 you will need to pull the number one sparkplug and spin engine until ...

my 1985 flhtc starter spins but won't pull in to turn over engine. I tapped it with a rubber mallet and it did engage. What do i need to replace? my 1985 flhtc starter spins but won't pull in to ...

my starter continues after I turn off ignition? Try tapping on one of the bolts on it one you should be able to tap to turn it off and the other if you tap should make it spin. By tap I mean hit with ...

washing machine takes about 1 hour between prewash and spin dry cycle. Water just dribbles in. check the operation of the solenoid valve check that the tap washer is opening with the turning of the ...

pipe is connected to water tap and is open.When pressing start button it starts spin dry. No water want to run into the drum I think you timer/control is messed up, unless the timer/control is set to ...