Questions & Answers for: Nissan spin solenoid

starter (bendix)does not engage, just spins I had my starter rebuilt and it "bench" tests fine however when it is in the car just the starter motor spins but the bendix does not engage. I have checked

shorts in my 280z now it is not working my car has a spinning noise and that trys to start the car after i turn it off. jump-starting it used to work now it doesnt. Sounds like the starter is spinning

...all.its making like a whining noise but not from a dead battier. best way i can describe it is free spinning What could the problem be? starter gear is not engaging the flexplate. solenoid mechanism ...

...2. Tap the solenoid with a wooden hammer handle, or broom handle, any long object. 3. WATCH out for spinning fans, belts, don't wear a necktie, etc... think safety. 4. Does that '' unstick'' your ...

vehicle will not start. it only spins over when a jumper wire is ran from the starter solenoid to the battery. when the ignition switch is on, there is full power, but ot will not start with the key ...

...to exchange ? can it be something else? No its not the solenoid, if that was the case the starter would just "click" but not spin the engine over. Have the battery load tested for a dead

good connection, and proper voltage at the starter(10 volts minimum while cranking). If the starter spins and no crank, the problem is most likely the Solenoid's pinion gear is stuck. Have someone hit

When I try to start, why does it sound like the starter is spinning and not engaging anything? plenty of battery but when turn the key it sounds like the starter is spinning but not engaging the ...

2010 frontier v6 stater spins but engind doens't turn intermintant issue, starter motor spins but engine does not turn over Either drive isn't engaging properly (faulty solenoid or wiring) or there is

2002 nissan pathfinder 3.5 starter is spinning but wont engage spinning evenwhen key is out have to disconnect battery to get it to stop spinning While you have the "BATTERY" (always the GROUND side ...