Questions & Answers for: speed touch Food Mixers

...product area below. When you open it, there is are contact points and a piece that has to touch to change the speed. It may just be slightly bent or out of place. Some food may have gotten in

kitchenaid speed controller (don,t work You need to adjust the mixer speeds. Obtain a copy of the KSM150PS Repair Part List from Kitchenaid.com. Remove the screw holding the End Cover and locate the ...

...purchased an ice cream freezer for my mixer. It is an older model and does not have a "stir speed" delineated. What is the equivalent of stir speed on the older models? -- 1 or 2? On ...

...Housing and visually verify that they are touching the Coils. You may also need to adjust the mixer speeds: Remove the screw holding the End Cover and locate the three screws from the Control Plate. ...

...Yesterday my wife was mixing bread dough in the Hobart. The hook began operating a variable speeds that were not selected. I touched and smelled the motor; it was cool, with no electrical ...

touch the armature. If you did nit take the brushes out at all. then your problem is the flag connectors are not in the correct terminals. the other problem is the possibility 

When I plug the mixer in it turns on immediately to the highest speed, it wont turn off unless I unplug it. The speed, control whether its on or not doesnt work. Something is amiss under the back ...

...TOUCH. Are the copper contacts jumping when the speed pulses? If yes you will need to SLIGHTLY twist the copper contact bar so that only one of the pointed contacts touches at low speed. Your ...

The speeds 1-4 on my kitchenaid 5qt mixer dont turn on and the other speeds setting are all the same speed The solution will probably be under the back cover. Are the switch contacts touching at speed

...is 8 full turns in from being not even in the hole (both sides) and on speed 1 the bottom screw does not even touch that step in the flat rod that activates the switch and moves the control