Questions & Answers for: Harley Davidson speaker works push cone

Question about 2000 FLSTC Heritage Softail Classic

1 Answer

coil. Terminal on top of ign coil goes to ignition circuit breaker (used to be points and condensor, you would have solid state magnetic pickup) in nose cone, right side of engine below push rod tubes

Ad

Question about 2001 FLHTCUI Electra Glide Ultra Classic

1 Answer

...is speaker is bad. Try pushing the cone inward while the radio is playing to see if you are getting any sound from the speaker if you do then the speaker is bad and needs to be replaced. Good

Ad

...speaker sometimes pops and sometimes does nothing the speakers on the tour pack work fine. when i use the channel controls on the handle bars to change the station it changes the station up weather i ...

Question about 2006 FXDBI Street Bob

1 Answer

how to install torque cones on a harley Take your exhaust pipes loose and drop the cone into the pipe. It has a lip that catch on the top of the pipe. Then, bolt the pipe back up.

Question about 2007 XL 883 Sportster

1 Answer

what are power torque cones Power torque cones are the cone like devices that are claimed to go in your exhaust pipes to prevent "reversion" in the exhaust system. What they really are, in my opinion,

Question about 2007 XL 883 Sportster

1 Answer

...Push the nose cone up into position making sure the dowel pin is aligned. Then, you can smack the nose cone at the timer cavity hole and generally it will pop back on the engine cases. If so, you ...

Question about 2007 XL 883 Sportster

1 Answer

ignition problem,bike started missing , then went too the front cylinder shuting down ! ignition system is crane fireball hi-4e have replaced the modual,spark plugs, wires , pickup modual runs for a ...

My 2009 Ultra Classic radio speakers don't work and CB doesn't work Code comes up see Dealer. I have to keep pushing speaker button to radio work. Hi Anonymous, please visit the website below and good

...push the wheel forward slightly to get it where you need it to be. THEN snug the cone nut to 15-20 ft-lbs (20-27 Nm). THEN check deflection at the loosest spot in the belt using a belt tension gauge ...

what is the proper way to use belt tensioner on a harley fxr Not sure what you are asking but... The belt tensioner gauge should be placed on the drive belt as close to its middle section as possible ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...