Questions & Answers for: speaker wire rca phono

...from radioshack ans some speaker wire solder pos to pos and neg to neg and voila you got some patch cable just make sure that the outside neg- part of the rca matches the neg lead you ...

...wire) at the speaker is for AMPLIFIED signal. You can't just modify one to fit the other and expect magic to happen. Be glad you didn't do it the other way around and modify an amplified (speaker ...

...RCA, for connection to the Speakers http://www.ehow.com/how_4793807_wire-boston-acoustic-proseries-amp.html http://www.ehow.com/how_5412465_connect-boston-acoustics-ba-speakers.html How to wire the ...

...speaker connectors for this unit RCA, Phono ,3.5 mm ? Does it have a speaker output - I'm sure it does? More likely it's the 3.5mm. which may look like for headphones. The RCA are for low level ...

how do you attach to speaker wires to the phono plugs Get phono plug ends (rca jacks) at radio shack. not a tough job to attach to the wires.

...speaker wire from the "pawn stereo" directly to the speaker. replace plate on sub to keep box sealed, and adjust receivers to desired level of bass & volume. You have spent $50 and now have a ...

...phono (RCA) output on your TV you could also use this to power the sub, in the worst case scenario you could use a single to single phono or rca cable to connect one of the output channels (left or ...

speaker wire connections. That's not just about the type of connector. It's about the signal going through those wires. A low level RCA/phono sub connection conducts a maximum 0.7 Volt. A speaker wire

speakers and receiver. Positive to positive and negative to negative for best sound. Connect turn table RCA jacks to receiver PHONO input, L & R. Connect devices to power and set receiver to PHONO, go

...would be greatly appreciated. remove rca plugs from speaker wires and wire the speakers to speaker connections on the back of receiver. The receiver may already have a phono input for a