Question about KV-32S26 32" TV
Sony Tv 29 Inchs, The Picture Keep Swiching off and replaced by fable shadowi pinky multi colour light The Picture Keep Swiching off and replaced by fable shadowi pinky multi colour light, I have re ...
...solution? Thanks in advance Kramer You may have a bad connection inside the picture tube or a bad solder joint on the picture tube driver board which plugs onto the neck of the picture tube. ...
...Sony rear projection tv picture blinks on and off after 5-10 minutes of use. It was fine until the last few months. Any suggestions? Sounds like a cracked solder joint. I would check the flyback ...
sony tv kv-29F1U flashing tv signal every five to ten seconds tuner needs replaced or taken apart and cross your fingers soldering joints, use silver solder look hard with magifiers for solder cracks ...
...TV has dry/ cold solder joints (loos connections) in convergence out section. Please check cold/ dry solder joints in convergence out section in TV, specially on pins of convergence out ICs. resolder ...
...sony KV-27s22 comes on realy good but now there is no picture. I used to be able to hit the side of the TV and the picture will come back on now it just zooms all the way to the top and then no ...
Question about KP-46WT500 46" Rear Projection HDTV-Ready Television
...Sony KP-46WT500 Projection TV. For some time it appears convergence went bad. I see multiple images, especially at edges and corners. As many as 3 images Red, Blue and Green. I am an Electronics ...
...bad solder connections around the flyback transformer as well as in the vertical sweep circuits. Please If you have no TV repair experience, call in a tech to assist you in this repair. Good Luck and ...
bad solder joints. Over time the TV when it gets turned on, these solder joints get hot, then when it gets cut off, these joints cool off, making tiny cracks,(bad joints) in the circuits. These joints
tv sony stop after 20 min standby led flashes 3 times HI, By three blink it means the B+ over voltage protection (OVP), unit goes to the standby mode then displays the 3 blink fault. This is because ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions